APS1 Probe Simulator.png
Images are representations only.

Probe Simulator

Brand: Spirax Sarco
Request Information
Favorite

The APS1 probe simulator is used in place of a level or conductivity probe to verify the correct operation of Spirax Sarco controllers.

It can also be used to diagnose wiring/probe faults. It is connected to the level probe or conductivity probe wiring, avoiding the need to fire the boiler or alter water levels, and is quick and easy to use.

The APS1 has switch settings covering all Spirax Sarco probe types and ranges.

A potentiometer provides the variable input to a capacitance controller, and 4 mm test sockets are provided for connection of a multimeter, which is used to check the voltage when simulating capacitance probes.

Switches simulate wet or dry (high or low resistance) conductivity level probe conditions, and resistors are built in to represent various conductivity probe ranges.

The APS1 is powered by the controller under test, so needs no batteries or external power supply.

The unit is fitted with two inputs, connected in parallel.

One is for connection of a PT2 or PT3 plug tail, and the other is a DIN 43650 connector as used on conductivity and capacitance probes.

Full operating instructions are supplied with each unit.
Features
  • A valuable diagnostic aid for Spirax Sarco boiler control installations.
  • Compatible with all TDS / level probes and controllers.
  • No need to fire boiler or alter water levels.
  • No battery or power supply needed.
  • Easy to operate.

Specifications

Brand

Maximum Ambient Temperature

  • 55° C

Protection Rating

  • IP40

Conductivity Probe Settings

  • 22 Ω, 68 Ω, 220 Ω, 680 Ω
  • 2.2 kΩ, 6.8 kΩ, 22 kΩ

Level Probe Settings

  • LP30: 6.8 kΩ / 15 kΩ
  • LP31: 6.8 kΩ / 15 kΩ
  • LP10-4 (high sensitivity): 6.8 kΩ / 15 kΩ
  • LP10-4 (Low Sensitivity): 6.8 kΩ / 15 kΩ

Capacitance Probe Range

  • 0-10 volts output

Materials

  • Case: Die-cast Aluminium
  • Coating: Nylon (Grey)

Documentation

Brochure

show more